DESIGN GUIDELINES
Designing for plastic injection moulding needs special consideration. The following series of articles offers help in a number of areas.
Design for Behaviour Over Time
Design for Assembly - Part 1(Press & Snap Fits)
Design for Assembly - Part 2(Mechanical/Staking)
Design for Assembly - Part 3(Welding)
Design for Assembly - Part 4(Bonding)
Design for Mouldability - Part 1(Introduction)
Design for Mouldability - Part 2 (Wall Thickness and Radii)
Design for Mouldability - Part 3 (Ribs)
Design for Mouldability - Part 4 (Bosses/Undercuts)
Design for Mouldability - Part 5 (Coring, Drafts)